| |
You are making an offer on a 4000 Liter Bertrams 316L Stainless Steel Reactor System located in France. This lot is being sold "as is, where is." We recommend that you contact an EquipNet sales representative to set up your own inspection.
Please Note: This machine is still installed at the seller's facility. A scope of work agreed to by the seller may be required before any removal operations can begin.
4000 Liter Bertrams 316L Stainless Steel Reactor System including: 4000 L stainless steel vessel, half pipe coil (4) zone jacket (pressures internal and jacket are unknown), dished top and bottom, top entering motor with anchor agitator HP unknown2500 liter stainless steel pressure reservoir1600 liter stainless steel pressure reservoir vertical packed glass columnBurkhardt vacuum pump, type P2J 220/140, rated 1460 U/Min.control panelprints available upon request- Manufacturer Bertrams
- Year 1968
- Capacity Size 4000 L
- Products Run Pharma
- Manual Available Yes
- Length 1786 MM
- Diameter 1612 MM
- Voltage 380 VOLTS
- Frequency 50 HERTZ
- Phase 3
- Estimated Shipping Weight 15,000 LBS
- Removal Difficulty MODERATE
- Nozzels misc., top manway
- Requires rigging or removal YES
- Requires a flatbed truck YES
- Level of shipment preparation necessary STILL INSTALLED
- Additional Component Dimensions misc. to be shipped with reactor: agit, columns, tanks, panel
Contact Information
If you need further information, please contact our Sales Department at 888.371.6555, outside USA at +1.781.821.3482, or click here to send us a message, or by email to sales@EquipNet.com
Payment Methods:
Certified Check, Bank Check, Company Check w/Bank Guarantee, or Wire Transfer
Crating, Rigging, and Shipping Info:
Buyer is responsible for all crating and shipping charges. EquipNet can furnish a quote upon request. Please contact sales@equipnet.com.
Location:
France
Dimensions: 1786 MM
Disclaimer
Please note: All listing descriptions take precedence over what may be showing in the photo. If you have any questions at all on this listing, please contact EquipNet.
|
Store